spgw piston seal How to Change the Oil on a Craftsman Rear Wheel Drive 650 Series Lawn Mower
2019-06-08
spgw piston seal How to Change the Oil on a Craftsman Rear Wheel Drive 650 Series Lawn Mower
The craftsman 650 series rear wheel drive mower is named after the Briggs & Stratton engine, which powers it.Engine power for rotating blades-Driven directly--and the self-Push the rear wheel by driving the belt.In order to keep the particles in the combustion chamber that are not likely to damage the piston seal and keep the piston properly lubricated, Sears recommends replacing the oil every season or every 25 hours after use.Run the engine until all fuel runs out.By doing so, you can avoid discharging gas tanks.If you have just filled the tank and need to drain, breathe the gas into the approved gas tank using a manual siphon.Unplug the start from the spark plug to prevent accidental start.Place the oil pan on the ground next to the oil plug side mower.If there is a mower, remove the cutter from the mower.Unscrew the oil cover and remove it.Use the handle to tilt the side of the mower and drain the oil into the oil pan.Shake the mower back and forth to release any oil trapped in the corner of the Quaker.When all the oil runs out, stand the mower upright.High-High quality SAE 30 oil.Pour a small amount of oil into the Quaker and often check the oil level with an oil ruler attached to the oil cap.It takes 20 ounces of oil to turn the box.Stop pouring when the oil ruler height is "full."Before reconnecting the spark plug, adding fuel and starting the engine, twist the oil cap back and tighten it.
Custom message

Chat Online 编辑模式下无法使用
Chat Online inputting...
DSH-How to Change the Oil on a Craftsman Rear Wheel Drive 650 Series Lawn Mower-10